normalizer (controller)
effects/toolsa module for normalizing sounds in your mix for gain-staging
this is the controller version, which is meant to be connected to an amplifier module; the amplifier will act as the normalization gain, and this module can be deleted afterwards to save cpu
here is how to use this module:
-
set the “reset” controller to 32768 to reset the module. by default, a gain of 0 db is being applied
-
while audio is being fed into the module, set the “profile” controller to 32768 to begin the profiling. the module will adjust its gain for the maximum peak value to normalize the audio to -0db
-
once you’re sure the audio won’t peak any higher, set the “profile” controller to 0 to stop the profiling. the gain will persist even as you save and reload the project/module
-
repeat these steps if you need to reprofile the audio
changelog
1.1
- initial release
controllers
group 1: main controls
- profile: enables profiling at value 32768
- reset: resets the module at value 32768